Half Buried cats!

[Tad Carlucci]

Disable Camera Constraints allows you to move your camera CLOSER, but not INTO. It's good for zooming in and moving close, to examine texture details or work with nano-prims.

The move-into option lets you look inside Avatars, and under ground, as well as inside prims.

There is a small hiccup when you want to put the camera right at the water level, but it works fine if you move lower and look up. Also, I think it works a bit better if you use the Ctrl Shift and Alt keys to move, zoom, rotate and pan your camera, rather than the Camera Controls floater, when moving your camera through the land and water surfaces.

Often, when I'm building, I'll lose a prim underground. Since I usually know, roughly, where it is, I'll open the Edit floater then click-drag to select an area. That will grab the prim/cat even if it's underground and you can use the arrows to drag it back up. This works best, though, when there's not a lot of other clutter (landscaping, other cats, etc).